ADP5063 How to configure DIG_IOx as stated in table 49 in datasheet?

Hi,

recently I started to integrate ADP5063 to my project. Now I stumble on how to reconfigure the DIG_IOx to another option set. We designed our PCB to use "1001" configuration, especially with the interrup output, but now I found no way to set this pin configuration.

How to set the pin configurations from Table 49 to the device?

Is there a way to reconfigure the chip to this configuration via I2C during runtime?

How to get the interrupt-Output on IO3?

Parents Reply Children
No Data