KCC's Quizzes AQQ305 about a mutual exponentiation equation
1. Quote of the month: "A train station is where a train stops. A bus station is where a bus stops. I have a work station on my desk, so..." - unknown
2. Quiz AQQ305 about finding a mutual exponential equation
Good luck, and try to be among the
View All
September Monthly Blog Quiz! Read the blog, take the quiz, and you could win a gift card
Quiz: How Well Do You Know Adaptive Power Switching?
Is your I/O module overheating? The AD74416H's Adaptive Power Switching (APS) can cut heat dissipation by up to 40% — but how well do you really understand how it works?
Read the blog first: Cooling
View All
ADP3050
Not Recommended for New Designs
The ADP3050 is a current mode monolithic buck (step down) PWM switching regulator that contains a high current 1 A power switch and all control, logic...
Datasheet
ADP3050 on Analog.com
Hi all,
"ADP3050 Buck Regulator Design Tool" can not design the ADP3050 in a buck-boost configuration that produces a negative output voltage from a positive input voltage.
In the datasheet 18 page, "INVERTING (BUCK BOOST) REGULATOR"
The circuit in Figure 29 shows the ADP3050 in a buck-boost configuration.
For example, following output setting is available for ADP3050?
VIN:+5.0V
VOUT:-12.0V
IOUT:0.5~1A ;need to set less current ?
Best regards,
sss
Hello,
when you follow the math on page 18 you will see that the available output current for a +5V to -12V application is less than 250mA, hence, for more output power you need a part with a bigger switch rating. Once you have to go away from the ADP3050 you should look for a more modern part with higher and maybe adjustable switching frequency. The ADP2380 should be an candidate. Look for Vin,min (4.5V) and the Absmax. There is a design tool for an inverting BuckBoost topology available for the ADP238X family.
Hello,
when you follow the math on page 18 you will see that the available output current for a +5V to -12V application is less than 250mA, hence, for more output power you need a part with a bigger switch rating. Once you have to go away from the ADP3050 you should look for a more modern part with higher and maybe adjustable switching frequency. The ADP2380 should be an candidate. Look for Vin,min (4.5V) and the Absmax. There is a design tool for an inverting BuckBoost topology available for the ADP238X family.
