Post Go back to editing

+/- rail from LTM8068

I would like to use the LTM8068 to drive various opamps. I like the galvanic isolation and the noise is acceptable. 

As I require a +15V / -15V rails, I intend to use two LTM8068. (Vout2+ is tied to Vout1- for the center tap)

My question: The inbuild post voltage regulator of the LTM8068 is a positive regulator. Will there be any problems by using one for the negative rail?

Thanks heaps! Henner

Before You Switch


Switching languages will make ADI Explorer unavailable. Resume your session by switching back to English and reopening ADI Explorer.