Hi
Are LTM8024 LTpowerCAD Design tool scheduled to release soon ?(DC1868A)
Customer would like to use it ,if it is in time their schedule.
Best regards
Thank you very much.
No expected release time yet for LTpowerCAD tool of the regulator. Customers may use LTspice for simulations. Thanks.
Hi,
This is the result I'm getting from simulating your schematic. V(n001) and V(n002) are probed from the run pins 1 and 2, respectively.
There is no large overshoot seen from the output. Make sure…
I simulate the LTM8024 with LTspice, but the results showing there's always overshoot before the output settling down.
Am I missing something here:
What are the Vc1 and Vc2? As I don't see these pins in LTM8024 datasheet.
Thanks
There is no large overshoot seen from the output. Make sure to do a sync release first before doing a simulation. Since you are simulating a startup condition for this test, then you should put a "startup" modifier to the .tran command.
Regards,