LTC3310S footprint

Hello, the recommended center pad should match the EPAD of the part, 1.5mm x 1.5mm. We should add that dimension to the drawing. Thanks for pointing that out.

Hi thank you for your reply.

Exposed pad is 1.5mm ×1.7mm and isn't square.

Is these condition good for Pd ?

And if PCB is 1.5mm ×1.5mm footprint, Is centered position better?

Best regards

Thank you very mcuh.

Hi Marty M, I'm an FAE closely working to the questioner. He's essentially asking if '1.5mm x 1.5mm' part mentioned in your answer was just a typo, which contradicts to what you say at first place. Just double checking.

Hi, The pad is 1.5mm x 1.7mm not 1.5mm x 1.5mm. I am trying to confirm with the package guys what is suggested. Sorry for the delya.