Hello, thanks everyone in advance
I am using Max12711 IC to monitor single Cr123 cell we are following instructions in this https://www.analog.com/media/en/technical-documentation/app-notes/how-to-use-the-max17201max17211-and-max17205max17215-to-fuelgauge-primary-cell-batteries.pdf I am getting voltage readings from IC as expected but the capacity readings are not accurate most of the times its either 0 or less than 20 % even for fresh out of the packet batteries I think i have made mistake in configuring IC registers for cr123 cell can any one help me with buttery profile for cr123 cell .
Notes if they are needed we are using 0.005 Ohm resistor for Rsense.
in our application we need to drive a load of 200mA for 2 Sec a few times.
Tagged
[edited by: GenevaCooper at 4:29 PM (GMT -5) on 4 Dec 2023]
