Power System Managers, Monitors & Sequencers

No, it no recommended to leave the SET_ or DISC_ inputs disconnected.

Without the sense resistor, there will be no voltage drop when using current transformer (CT) sensors or transducers. Consequently, measuring the battery voltage will not be possible. Therefore, sense…

LTC2937: FAQ

LTC2992: FAQ

MAX15303: FAQ

Question: Could you tell me the response of the MAX16050/MAX16051 to an OV on a monitored rail? It says it sets the OV interrupt output, but we want to make sure it doesn’t also shutdown. Answer: An overvoltage…

MAX16050ETI+: FAQ

The LTC2937 can get its VDD power either from the VPWR regulator or an external source. When VDD drops below the undervoltage lockout (UVLO) level but stays above about 1V, the chip can still pull the…