There is no hysteresis for the OT output. When temperature surpasses your programmed Overtemperature limit, OT will pull low. As soon as temperature drops below the Overtemp. limit, OT will pull high again…
Data sheet page 6 states "There are two options for the behavior of the PWM outputs at power-up." How to select option 1 or option 2?
This will depend on the device you are selecting. For minimum duty…
Make sure the DXP pin is not connected to Ground. If an external “diode” pin is shorted to ground or left unconnected, the temperature is read as 0°C. Whatever configuration you have set for OT1 and OT2…
Make sure the DXP pin is not connected to Ground. If an external “diode” pin is shorted to ground or left unconnected, the temperature is read as 0°C. Whatever configuration you have set for OT1 and OT2…