Power FAQs - Documents - Power Management - EngineerZone

Power Management

Documents Power FAQs

Most Helpful Articles

MAX14626 Datasheet clarification: Figure 1

Question: In Figure 1 of the datasheet (Rev. 0, 3/12) of MAX14626, why does the loop require two protectors in series? Answer: A single MAX14626 can act as a current loop protection device. Two are shown in the figure to indicate that they can be used…
MAX14626: Where to place current loop protector in current loop?

In the application diagram of the datasheet, the current loop protector is placed after the sensor device and before the analog readout. This is because most of the time, the supply bus will drive more than one sensor. If we put the current loop protector…
MAX14721ATP+: FAQ

MAX14721ATP+: FAQ
MAX14870/MAX14872 Slope Control Feature

The MAX14870/MAX14872 datasheet (19-7062; Rev 1; 6/17) section on slope control page 11 describes the slope control features of the MAX14871. This is a datasheet typographical error, and "MAX14871" should be replaced by "MAX14870/MAX14872." These slope…
MAX14871EVKIT#: FAQ

MAX14871EVKIT#: FAQ