There is an incorrect signal routing shown in the MAX2851 datasheet (Rev 1; 3/2010) Typical Operating Circuit, page 37. The RXRF2- and RXRF2+ pins should be connected internally to the differential input of the receiving amplifier. VCC_MXR1 and VCC_LNA3 should not be connected there as they are power supply pins.
Learn
Libraries
Upcoming Learning & Events
- The Missing Middle in AESA Development: From Beamforming ICs to Scalable Apertures
- Motor Drive Fundamentals Session 3: Safe Torque Off Architectures and Claiming Fault Exclusion
- Motor Drive Fundamentals Session 2: Designing for EMC Success in Modern Motor Control Systems
- New Lowest-Power ZIF-Based SDR Transceivers for RF Instrumentation and Defense Applications
- View All Webinars
Community Hub
Resources
Challenge Yourself
KCC's Quizzes AQQ304 - A pure logic
1. Quote of the month: "I am not lazy, I'm just in energy-saving mode" - unknown
2. Quiz AQQ304 about finding a pure logic puzzle
Mike is looking at Anne, but Anne is looking at Paul.
Mike is married, but Paul is not.
Question:
Is a married
View All
What's Brewing
September Monthly Blog Quiz! Read the blog, take the quiz, and you could win a gift card
Quiz: How Well Do You Know Adaptive Power Switching?
Is your I/O module overheating? The AD74416H's Adaptive Power Switching (APS) can cut heat dissipation by up to 40% — but how well do you really understand how it works?
Read the blog first: Cooling
View All