AD9959: FAQ

  • Created
  • Updated
Was this helpful?
  • AD9959 evaluation board clock

    Question We are currently using an AD9959 DDS evaluation board. I am interested in clocking the system using the external quartz option. Could you please suggest an option for the quartz crystal? Answer…
  • AD9959: ADIsimDDS_spectrum

    Question Currently, we found the bandwidth of single tone output from frequency response in the ADIsimDDS tool is 800KHz. Pls see the attached. Is it all right for such wide bandwidth? Or is there…
  • AD9959: FSK modulation performance

    Question I did an experiment of AD9959EVB. System Clock is 500MHz, FTW0 = 10MHz, FTW1 = 10.1MHz, use P0 Pin to switch the DAC's output frequency.When the switching time is 20us, then the DDS's output…
  • Ad9959: Oscillator

    Question Is the ballon a t Pin 8 & 9 required when using an oscillator to drive the inputs or is the ballon just used to accommodate the mismatch of the external clock input impedance on the Eval-board…
  • Differential Phase Noise

    Question Hello, I am working on an application which needs two RF outputs at 80MHz witha programmable phase difference between them. The application is very sensitiveto phase noise between the two 80MHz…
  • If I update the FTW of the AD9959, will the phase difference remain?

    The FTW resets the accumulator to its default state according to the registers listed in Table 32 of the datasheet. Enabling or disabling these registers can assist with the accumulator reset depending…
  • Is Data Valid Time (tDV) of 12nS for AD9959 correct? Or should it be 1.2nS instead?

    Question Data Valid Time (tDV) is indicated as 12ns minimum (refer to Table 25 On page 31 of the AD9959 RevB data-sheet. This can't be true with respect to the fast 5ns serial-data clock? Should it…
  • The AD9959's SYNC_CLK has no signal. What should I check to fix this?

    Question The AD9959's SYNC_CLK has no signal. What should I check to fix this? Answer The SYNC_CLK should be running by default in crystal REF CLK mode or in any other REF CLK mode. However, the following…
  • The AD9959's SYNC_CLK has no signal. What should I check to fix this?

    Question The AD9959's SYNC_CLK has no signal. What should I check to fix this? Answer The SYNC_CLK should be running by default in crystal REF CLK mode or in any other REF CLK mode. However, the following…

Before You Switch


Switching languages will make ADI Explorer unavailable. Resume your session by switching back to English and reopening ADI Explorer.