Post Go back to editing

MAXM86161EVSYS Flex Cable - Using 3.3V supply instead of 1.8V

Category: Datasheet/Specs
Product Number: MAXM86161

Hi EngineerZone,

I am looking at integrating the MAXM86161OSBFLEX from the breakout board into a prototype device. Since my MCU runs on 3.3V, is it OK to power the flex cable using 3.3V instead of the 1.8V that the dev system runs on? Looking at the components individually (Sensor Hub, AFE, accelerometer), it seems that 3.3V is within the normal operating voltage but want to confirm.

Thanks