TMC2240 EVA KIT

Question

I purchase the TMC2240 EVA KIT and after installing PMCL-IDE software I get : Fount 1 PIDs : VID_2A3C&PID_0700 : Driver not found and the software abort... Have a look to the screenshot. Thanks for help

FabianMuehlberger · Accepted Answer

The Trinamic EVAL system consists of a base-board called L andungsbruecke and the EVAL Board that has the motor driver on it. I am referring to the Landungsbruecke itself and not to the EVAL board. 
 The problem is, that the firmware on the board that needs to be updated. In the TMCL-IDE: Check the firmware version of your Landungsbruecke board, this should show up on the left side under Connected devices. If it is not v3.09 an update might be needed. 1. Go to https://github.com/trinamic/TMC-EvalSystem/releases/tag/3.09.6 and get the latest release. Depending on the revision of your Landungsbruecke, download the Hex file.To see what file version is needed, take a look at the top-mark of the processor chip on the Landungsbruecke. 
 
 If the top-mark is "MK20DN256VLL10", you should use the newest "Small" version of Landungsbruecke firmware (example: LandungsbrueckeSmall_v3.09.2_BL.hex). 
 If the top-mark is "MK20DN512VLL10", you should use the non-small version of Landungsbruecke firmware (example: Landungsbruecke_v3.09.2_BL.hex). 
 
 2. Click on Firmware Update in the upper right band. (it is the green arrow down) 
 3. Upload the hex file to the Board 
 If all works, the Landungsbruecke should have the latest v3.09 Firmware Version installed. 
 Best Fabian)

Partner Forums

Partner Libraries

Products Mentioned

TMC2240 EVA KIT