Hi
When downloading program to ADCUM360 by J-link, there are errors caused failure as below.
"Connecting ...
- Connecting via USB to probe/ programmer device 0
- Probe/ Programmer firmware: J-Link V9 compiled May 7 2021 16:26:12
- Device "ADUCM360" selected.
- Found SW-DP with ID 0x2BA01477
- Failed to power up DAP
- Found SW-DP with ID 0x2BA01477
- Failed to power up DAP
- Target interface speed: 200 kHz (Auto)
- VTarget = 3.319V
- Found SW-DP with ID 0x2BA01477
- Failed to power up DAP
- Found SW-DP with ID 0x2BA01477
- Failed to power up DAP
- ERROR: Failed to connect.
Could not establish a connection to target. "
How to fix this problem?