Hello,
I am using Segger J-Link to program/debug an evaluation board with the microcontroller ADuCM3029, from Analog Devices.
This is the evaluation board: https://www.analog.com/en/design-center/evaluation-hardware-and-software/evaluation-boards-kits/eval-aducm3029-ezkit.html
I was able to run my application for a few months, but today I got stuck after flashing the device.
I can not connect to the microcontroller via J-Link Commander or communicate with it via IDE as well. The image below show the error I get when I try to do it:
I know that it is not a problem with my J-Link, because it works with other boards. However, I would like to be able to connect to my device and perform a flash reset.
Do you any clue about how to do it?
Best Regards,
Luis Possatti
