AD9371.H

Please download the software package from the below link and check the path below for mykonos.c ,mykonos.h files.

https://www.analog.com/en/lp/001/transceiver-evaluation-software.html

PrakashRP said:

am trying to set custom Tx frequencies each time with the setup.

You can use setRfPllFrequency() API to set the RF PLL frequency.

Thanks for the reply.

With this setRfPllFrequency(), will i be able to change the frequency dynamically from sdk ? when the target is available using console/TCL command?

Can you please share us the error that you are getting while trying to port the no-OS to sdk?

https://wiki.analog.com/resources/eval/user-guides/mykonos/no-os-setup

Thanks for the reply,

I am getting the error as "no such file found" for each of common.c,common.h,mykonos.h, so on for all the realted library files and .c files (even though i have sourced entire src directory ). If i keep on adding the files one by one again the error increases.

Thanks for the reply,

I am getting the error as "no such file found" for each of common.c,common.h,mykonos.h, so on for all the realted library files and .c files (even though i have sourced entire src directory ). If i keep on adding the files one by one again the error increases.

Can you pls crosscheck if the path to your workspace is correctly included in the sdk environment?

Are you following the procedure explained in the below link properly.

https://wiki.analog.com/resources/eval/user-guides/mykonos/no-os-setup#ad9371ad9375_no-os_setup

Thanks I have tried the above too. But still getting error.

Can you please share the complete snippet of the SDK folder ?

Pls find the attached snippet. After importing and including the specific paths, i am getting these errors.

You would face this issue when you are not able to include all the paths of the folders properly.

Have you added the paths of the folders in C/C++ Build → Settings → Tool Settings → gcc compiler → Directories section .

Will be moving to No-Os forum for further comments .

Hi PrakashRP ,

did you follow the instructions here for building your application? https://wiki.analog.com/resources/no-os/build?rev=1743066267

Regards,

G

Hi,

Thanks for the resource link.

I have followed this already, and afterwards facing the above issue.

Hi,

Thanks for the resource link.

I have followed this already, and afterwards facing the above issue.