iio-oscilloscope

Hi Team ,

I would like to update my Exact progress till now , so that you might understand what the problem is. I am not able to obtain the signals on the iio-oscilloscope , before that itself , the serial context is not getting enabled . I even installed the iioserialport latest version too, but the problem remains same. I have attached the screenshots for your reference.Kindly Support.

Use the serial context(from the image on the right) for no-OS.
https://wiki.analog.com/resources/tools-software/no-os-software/iio

Hi Team,

I have followed the steps outlined in the documentation you provided, but I am still unable to obtain the serial context. However, I am able to establish a serial data connection through both the Vitis Serial Terminal and PuTTY.

Could you please advise on the specific actions I need to take to successfully obtain the serial context, so that i will be able to see the AD9361 Device on the IIO-Oscilloscope.

Regards,

Mark

Hi Mark23 ,

When building the project, you have to run the command make IIOD=y, as you can see in the following Wiki page:

https://wiki.analog.com/resources/tools-software/no-os-software/iio

Then, when running the application, you should get the following message in your serial console:

Running IIOD server...
If successful, you may connect an IIO client application by:
1. Disconnecting the serial terminal you use to view this message.
2. Connecting the IIO client application using the serial backend configured as shown:
	Baudrate: 921600
	Data size: 8 bits
	Parity: none
	Stop bits: 1
	Flow control: none

You have to close then the connection and open IIO-Osc and check Serial Context with the settings specified in the above message. Then you should be able to connect to your setup.

Regards,

George