no-os failed to open HW ADRV9002 Evaluation Board

Hi DrMurad ,

Which no-OS and what HDL version ar you using ? master / 2019_R2 ? 
Also, were any of the no-OS code or HDL modified ?

To me it sounds like you have a low level (SPI communication?) problem, caused by either non-matching no-OS and HDL but we need more info.

Hello Buha,

I agree with you that it seems a SPI issue.

Both HDL and no-os are 2019_r2

I built the hdl and no-os from source files without any changes.

The 3 green LEDs on the ADRV9002 are on. the red LED is off meaning VADJ is 1.8v

Regards,

Murad

Where can I find a BOOT.bin for the ADRV9002 and ZEDBOARD?

The steps I followed are here:

https://wiki.analog.com/resources/eval/user-guides/adrv9002/no-os-setup

But a tested BOOT.bin will help me eliminate building issues

Regards,

Murad

Unfortunately we don't have BOOT.bin files included in our automatic builds.

I built the BOOT.bin. When I power the ZEDBOARD, it boots and prints the ''Hello" but nothing else. when debugging, I noticed it stuck at line 168 [ret = adrv9002_setup(&phy, adrv9002_init_get());].

BTW: as shown in the picture, I am still getting lots of warnings and some related to SPI...why all these warnings?!?!

Progress:

while debugging, I noticed that the GPIO offset was set to 78 for the ZYNQ. I am familiar with the 7Z035 and it was 54. When I changed it to 54, the system worked!

Even though this solved the issue, I am kind of frustrated if this is a BUG...how come it made it to git!!!!

Hi DrMurad ,

I just realized zedboard+adrv9001 was not supported in 2019_R2, support was added more recently on master:

2019_R2 code:
https://github.com/analogdevicesinc/no-OS/blob/2019_R2/projects/adrv9001/src/hal/parameters.h#L54-L58

master code:
github.com/.../parameters.h

I was stuck in this problem for one week and I able to find solution successfully. 

Step I followed to solve this issue are:

1.  Turned off all antivirus
2.  Run sdk and open the default no-os project 
3.  Removed the Debug file from the project 
4.  Clean the project
5.  Shown in the attached picture, this is the most important step ( open the adrv9001 -> scr -> hal -> parameters.h) and changed the <#if defined(PLATFORM_MB)
   #define GPIO_OFFSET 54
   #else
   #define GPIO_OFFSET 54 //78>
6.  Rebuild the project
7.  Run it on zedboard, now it start working