Q: The TEMP_OUT reading is quite a bit higher than the ambient temperature. Is this normal? A: ---------------------------------------------------------------------------------------------------------------------------- Yes, this is normal. Here are some key points to consider: Using Theta-JA and power dissipation, one can compute the estimated temperature rise in the hottest junction inside of the ADIS16xxx devices. For example, on the ADIS16485 Power Dissipation = 3.3V x 0.197A = 0.65W ( ADIS16485 Datasheet, Rev C, Table 1, Page 5 ) Theta-JA = 22.8 C/W ( ADIS16485 Datasheet, Rev C, Table 4, Page 7 ) Estimated temperature rise = 0.65W x 22.8 C/W = 14.8 C TEMP_OUT is not calibrated for any specific mounting configuration, airflow or other local thermal influences. TEMP_OUT's primary function is to be a relative control variable in the device's internal thermal calibration TEMP_OUT accuracy, at the internal point of measurement = +/-10C Therefore, observing TEMP_OUT at +25C above the ambient temperature is possible. We hope that this helps!