ADIS16497 does not output data during burst read

I try to read data from the ADIS16497 using burst read. But I don't get any data. The IMU should output a BURST_ID (0xA5A5) in segment 1. I don't even get that (see file burst_read.png).

If I read the PROD_ID I get the correct product id value 0x4071. So I know that the SPI works (see file ID_read.png).

The serial clock is set to 2.8125 MBit/s.

attachments.zip
Parents
  • 0
    •  Analog Employees 
    on Feb 21, 2018 6:11 PM

    This particular model does not support Burst Mode and is actually no longer available.  The three ADIS16497 models that are available now, do support Burst Mode communication. I am pretty sure that this particular unit came to you through a special request, which our local office arranged for your group.  They are now aware of your desire to use Burst Mode and will reach out to you, to discuss the best way to help you.  I am going to mark this with a "Correct Answer," but please do let me know if you are not contacted.  We look forward to hearing about your progress and to any new discussions that you start in this forum, in the future.

    Thank you!
    Mark

Reply
  • 0
    •  Analog Employees 
    on Feb 21, 2018 6:11 PM

    This particular model does not support Burst Mode and is actually no longer available.  The three ADIS16497 models that are available now, do support Burst Mode communication. I am pretty sure that this particular unit came to you through a special request, which our local office arranged for your group.  They are now aware of your desire to use Burst Mode and will reach out to you, to discuss the best way to help you.  I am going to mark this with a "Correct Answer," but please do let me know if you are not contacted.  We look forward to hearing about your progress and to any new discussions that you start in this forum, in the future.

    Thank you!
    Mark

Children
No Data