ADIS16460 SYNC

marky on Aug 23, 2016

i am thinking to use the adis16460 with external clock to synchronize it with my control loop (Direct Sample Control MODE), i will be happy if you can please explain me about how this effects system performance as i came across the next line:

"The sync input clock functions below the specified minimum value but at reduced performance levels" ?

i am planning to provide a 2kHz clock signal, so i assume that the low pass filter configuration (as seen in figure 29) will be all most the same as 2KHZ is very close to the default 2048Hz , is that assumption correct?

best regards

Mark

Top Replies

marky Sep 11, 2016 +1

Hi Mark

i did the "fine tuning" as you suggested , every thing seems to work fine and there is no inconsistency.

thank you very much!.

Mark

Parents

0 NevadaMark

on Aug 23, 2016 6:22 PM over 4 years ago
Thank you for your post. We would not anticipate major changes in performance when using 2000Hz clocks. That note was meant to discourage those who might be tempted to offer much lower clock rates, which could under-sample the sensor responses.
Cancel
Up 0 Down

Reply

Verify Answer

Cancel

Reply

0 NevadaMark

on Aug 23, 2016 6:22 PM over 4 years ago
Thank you for your post. We would not anticipate major changes in performance when using 2000Hz clocks. That note was meant to discourage those who might be tempted to offer much lower clock rates, which could under-sample the sensor responses.
Cancel
Up 0 Down

Reply

Verify Answer

Cancel

Children

No Data