we are working on a vibration measurement project for oil tank of transformer.
Our main parameters show as following:
BW: 2kHz or more;
Resolution:4mg/LSB or higher;
FS:±5g or more;
Noise: rms< 20mg.
Q1:Colud you recommend one sensor to me? Or will ADIS16006 satisfy my parameters?
Q2:The difference between ADIS series(Industry application?) and ADXL MEMS series(for consumer electronics?)? We have tried one MEMS of ST,but failed because of bad frequency responce.
Q3:If setting the BW=2.26kHz,then I should sample at 4.52kHz or what?
Thanks in advance for any reply.
You are most welcome! I look forward to hearing about how things progress and to any future discussions that you start in our Engineer Zone.
Good luck with your project!