ADISUSB Trigger Support on ADIS16223

Hello Kaos,

I branched this to another discussion, since this question is different enough from the original question. Unfortunately, the ADISUSB and companion ADIS16220 evaluation software do not support this mode.  The key limitation is that the ADISUSB does not have the ability to monitor the busy signal (on DIO1 or DIO2). We are upgrading the Vibration Evaluation Program to include support for the ADIS16223 on the EVAL-ADIS, which does support the busy signals, but this upgrade is not scheduled for completion until February 2014. At this time, this program supports the ADIS16228 and ADIS16229 sensors. The revision history and development plans for this software is available for viewing at the following Wiki link:

http://wiki.analog.com/resources/eval/user-guides/inertial-mems/imu/vibrationevaluationprogram#software_revision_history

So, if you need to use the ADIS16223, with your own PC-based software that supports automatic trigger mode, you may need to develop your own package, using the EVAL-ADIS and the VB.NET DLL at the following location:

http://ez.analog.com/docs/DOC-2858

Another option would be to pair the ADIS16223/PCBZ with an embedded processor platform that comes with an integrated development environment (IDE) that would enable firmware-level and PC-level programming for this type of purpose.

I hope that helps.

Best,

NevadaMark