ADIS16135 SPI Interface Configuration

Question

How do I configure the ADUC7026 to communicate with the SPI on the ADIS16135?

NevadaMark · Accepted Answer

Embedded processors typically support SPI communications with multi-purpose SPI ports that have some configurable parameters. These parameters could include serial protocol (SPI, I2C, etc), data length, clock polarity, clock phase, bit order, serial clock rate, etc. While it is important to check the sensor's datasheet for product-specifc settings, Table 7 in the ADIS16135 Datasheet (page 8) offers a summary of typical configuration parametes to look for, which are typically found in serial port control registers. Table 7's contents are provide here, for convenience.

Processor Setting 
 Description

Master 
 The ADIS16135 operates as a slave.

SCLK Rate ≤ 2 MHz 
 Maximum serial clock rate.

SPI Mode 3 
 CPOL = 1 (polarity), CPHA = 1 (phase).

MSB-First Mode 
 Bit sequence.

16-Bit Mode 
 Shift register/data length.)

Popular Forums

Product Forums

Application Forums

Design Center Forums

Highlighted Webinar

Places

Libraries

Latest Webinars

Challenge Yourself!

What's Brewing

Places

Resources

Highlighted Blogs

Latest Blogs

ADI Blogs

Visit ContentZone

Featured Content

View Content By Industry

View Content By Technology

Products Mentioned

Thread Details

ADIS16135 SPI Interface Configuration