ADIS16228 Remote Evaluation

Question

I am concerned that the interface PCB and evaluation board (ADISUSB) will influence the vibration I am trying to measure. Do you have any tools or information that will help me connect to the ADIS16228?

NevadaMark · Accepted Answer

The attached file may provide an idea for how to use the ADIS16228/PCBZ and ADISUSB to accomplish this goal. There are a couple of differences between the ADIS16223 (shown in the attachment) and the ADIS16228 : 
 
 The ADIS16228CMLZ attaches to the application surface using four machine screws (M2), not a single 10-32 stud. 
 The ADIS16228CMLZ uses a different mating connector than the ADIS16223 , but the same principle will work. Cut the interface board in a manner than leaves the ADIS16228 's mating connector intact. 
 
 A few more notes on doing this: 
 
 Keep the length of the ribbon cable as short as possible. While some have been successful using longer cables, we have observed that 12 inches is a good limit in most cases. 
 For those who do not have a ribbon cable supplier and do not want to make your own, Samtec offers standard-length cables and free samples. Check out their TSCD series at www.samtec.com/TCSD . For example, a 12-inch ribbon cable for this remote connection would be Samtec part number, TCSD-08-D-12.00-01. Request a sample at www.samtec.com/samples . 
 Note that this cable and the ribbon connector on the ADIS16228/PCBZ interface PCB has 16 pins, while the mating connector on the ADISUSB has only has 12 pins. Make sure that pins 1-12 on the ADISUSB connect to pins 1-12 on the ADIS16228/PCBZ , per User Guide UG-363 . 
 Download ADIS16228 Evaluation Software from the ADISUSB web site ( www.analog.com/ADISUSB ), under the SOFTWARE AND TOOLS tab.)

Partner Forums

Partner Libraries

Products Mentioned

Associated Drivers

ADIS16228 Remote Evaluation