Important: For full functionality of this site it is necessary to enable JavaScript. Here are the instructions how to enable JavaScript in your web browser.

MEMS Inertial Sensors

Q&A ADXL357 Self Test

MEMS Inertial Sensors requires membership for participation - click to join

ADXL357 Self Test

nrsk 4 months ago

Hello,

I am considering using self-test with ADXL357.

In this case, should I set the ST1 and ST2 registers from 0x03 to 0x01?

Or should I set them in the order of 0x03 to 0x00?

I would like to know if the result of 0x00 is the same as the result of 0x01.

Best Regards,

0 NevadaMark 4 months ago

Thank you, for your post. The US-based staff, which supports this product, is on holiday right now. We will get back to you, as soon as practical, after the holiday.
Cancel
Up 0 Down

Reply

Verify Answer

Cancel
0 parziwal 4 months ago in reply to NevadaMark

Hi ,

I would also like to know if the Settling time for the Self-test value.

Is the self-test value delay dependent on the ODR setting?

Thank you

With best regards
Cancel
Up 0 Down

Reply

Verify Answer

Cancel
0 NevadaMark 4 months ago

After a bit of research on this, it appears like you will want to set SELF_TEST register to 0x01 to put the part into self-test mode and then write 0x03 to apply the self-test force.

FormerMember Am I understanding this correctly?
Cancel
Up 0 Down

Reply

Verify Answer

Cancel
0 parziwal 3 months ago in reply to NevadaMark

Yes that is correct
Cancel
Up 0 Down

Reply

Verify Answer

Cancel
0 parziwal 3 months ago in reply to parziwal

Hi ,

Could you please update us .

Thanking you

With best regards

Srivatsa
Cancel
Up 0 Down

Reply

Verify Answer

Cancel
0 parziwal 3 months ago

Hi

Could you please let me know about this

Thanking you
Cancel
Up 0 Down

Reply

Verify Answer

Cancel