Hi
We'll use EVAL-ADX343Z-M with I2C.
In user guide,
Only jumper setting is written.
Does ADUC7026 select SPI/I2C automatically ?
(or are other settings required? )
Best regards
grammer check
[edited by: Jma at 11:28 AM (GMT -4) on 5 Aug 2021]
Hi
We'll use EVAL-ADX343Z-M with I2C.
In user guide,
Only jumper setting is written.
Does ADUC7026 select SPI/I2C automatically ?
(or are other settings required? )
Best regards
Hi Jma,
Searching in our archive, I was able to find the firmware to allow the motherboard to communicate using I2C (see attached file). I do not have a Keil uVision license to build the project for your. If you have the means, just make sure that the I2C write and read address are as below (0xA6 and 0xA7 respectively), to properly communicate with the ADXL343.
Let me know if this helps.
Pablo.
Thank you for your reply.
And I have some question.
Your XL350 EVB Firmware have .hex file(below).
But that is ADXL350.
Can we use this hex file with below ARMWSD in ADXL343?
(Are other modification required for difference between ADXL343 and ADXL350?)
Best regards
Thank you for your reply.
And I have some question.
Your XL350 EVB Firmware have .hex file(below).
But that is ADXL350.
Can we use this hex file with below ARMWSD in ADXL343?
(Are other modification required for difference between ADXL343 and ADXL350?)
Best regards
