I want to lock the modifications of the sensor's register, setting the USER_LOCK register. But although I set that register to '1', the WR register data is not changed from 1 (Write enabled) to 0 (Only read). Also, the state vector (SV) is not changed from 00 "Initialization" to 01 "Running Mode". I have followed the sequence defined in the ADXRS910's datasheet.
Does anyone know how can be set this sensor to only read mode?
Thanks in advance,
Setting the USER_LOCK bit to “1” should cause the part to enter run mode.
You can confirm that the USER_LOCK command is being sent by issuing the following command and getting the appropriate response as outlined on Page 48 of the datasheet:
Command = 0x8000148F. Response =0x0080149E
I take profit this post to ask you a related question to this gyro. We've just finished integration of 1xADXC1501 and 2xADXRS910 to obtain 6 DoF. I would like to share with you the sampling logs of the gyro output under light shock. I'm afraid that the ADXRS910 g-sensivity values are above the spec (given we've set all the config correctly).
Can I send you the log in order to get a feedback?