EVAL-ADIS2 board external sync

Hi,

I was wondering if it was possible to connect an external sync to the EVAL-ADIS2 board? I am hoping to drive a ADIS16465 in burst mode with an external sync. I know https://ez.analog.com/mems/f/q-a/90967/external-clock-with-adis16488-eval-adis2 mentions using the DIO pins on the onboard micro controller but I would like to use a separate function generator to drive the ADIS16465

Thank you in advance,

Greg

Parents
  • 0
    •  Analog Employees 
    on Apr 29, 2019 5:20 PM

    Hi Greg,

    Thank you for your post!  What does it have to be in Burst Mode, if you are using the evaluation tools?  As long as the data is collected, for each frame, does it matter if the evaluation software uses the Burst or individual register reads (standard for eval software)?  With respect to the External Sync, let me review the ADIS16IMU4/PCBZ Wiki Guide and see if that has enough information to figure out the correct pin (on J1), to drive the external sync.  

    (Nevada)Mark

Reply
  • 0
    •  Analog Employees 
    on Apr 29, 2019 5:20 PM

    Hi Greg,

    Thank you for your post!  What does it have to be in Burst Mode, if you are using the evaluation tools?  As long as the data is collected, for each frame, does it matter if the evaluation software uses the Burst or individual register reads (standard for eval software)?  With respect to the External Sync, let me review the ADIS16IMU4/PCBZ Wiki Guide and see if that has enough information to figure out the correct pin (on J1), to drive the external sync.  

    (Nevada)Mark

Children