ADIS16209: FAQ

Was this helpful?
  • Article

    ADIS16201 and ADIS16209 Pins 8 and 10 Grounded - Performance Issues

    Q I initially used the ADIS16201 in my design. I tied pins 8 and 10 to ground. Later, I redesigned my system and upgraded to the ADIS16209. Will ADIS16209 work even if pin 8 and 10 is connected to ground…
  • Article

    ADIS16209 Datasheet Error: Address code length

    TITLE ADIS16209 Datasheet Error: Address code length DOCUMENT ADIS16209 Datasheet REVISION E LOCATION Page 12 (click here), left column, first paragraph, line 8 DESCRIPTION…
  • Article

    ADIS16209 Datasheet Error; SPI Address Code Missing MSB

    TITLE ADIS16209 Datasheet Error; SPI Address Code Missing MSB DOCUMENT ADIS16209 Datasheet REVISION E LOCATION Page 6 (PDF) : Figure 3, Figure 4 DESCRIPTION The…
  • Article

    ADIS16209 Datecode Revision Change

    Q What is the meaning of this „R“ in the Datecode 1224R of the ADIS16209. A The “R” indicates that these units have had the firmware upgrade, so they would behave the same way as units with later…
  • Article

    ADIS16209 Evaluation Tool Overview

    Q: Where do I find information on evaluation tools for the ADIS16209 Tilt Sensor? ---------------------------------------------------------------------------------------------------------------- …
  • Article

    ADIS16209 self-test

    Q We have a problem with the self-test of ADIS16209 at power-on. Is it correct that there is a possibility to disable this function at the power-on setting the bit 10 in the register MSC_CTRL? We have…
  • Article

    ADIS16209 Self-Test Management

    Q: When my ADIS16209 starts up, STATUS = 0x0020, which indicates a self-test failure, but the rest of the operation seems to be fine. Is this real? What should I do? ------------------------------…
  • Article

    ADIS16209/ADIS16265 Lead Integrity

    UPDATE ALERT! Please visit the following link for an updated set of assembly instructions: FAQ: ADIS162xx LGA Assembly Guidelines Start of older assembly instructions, for historical reference…
  • Article

    ADIS16209/ADIS16265 Pb-free Assembly Tips

    UPDATE ALERT! Please visit the following link for an updated set of assembly instructions: FAQ: ADIS162xx LGA Assembly Guidelines Start of older assembly instructions, for historical reference…
  • Article

    ADIS16209: Stability and sensitivity

    Q For my application, timing is nearly no problem. I would rotate the sensor slowly (3 rev/min) around the axis which inclination should be determined. The measured acceleration shows a sine-dependency…

Before You Switch

Switching languages will make ADI Explorer unavailable. Resume your session by switching back to English and reopening ADI Explorer.