is re initialization of ADF7020-1 generates interrupt?

Hi Polmon,

Even if the master is off, the ADF7020-1 will continue operating as configured, as long as power is still applied to it. So, it will remain in the Rx state and will continuously receive data until instructed to go to another state.

The INT/LOCK pin is asserted upon detection of the sync word, and is automatically deasserted again after nine data clock cycles.

Please refer to your previous query, https://ez.analog.com/low-power-rf-transceivers/rf-transmitters-and-transceivers/f/q-a/97838/in-adf7020-1-why-interrupt-is-fired-even-master-is-off-is-adf7020-1-check-for-valid-sync-byte-for-generation-of-interrupt

Regards,

Aldrich

Hi Polmon,

Even if the master is off, the ADF7020-1 will continue operating as configured, as long as power is still applied to it. So, it will remain in the Rx state and will continuously receive data until instructed to go to another state.

The INT/LOCK pin is asserted upon detection of the sync word, and is automatically deasserted again after nine data clock cycles.

Please refer to your previous query, https://ez.analog.com/low-power-rf-transceivers/rf-transmitters-and-transceivers/f/q-a/97838/in-adf7020-1-why-interrupt-is-fired-even-master-is-off-is-adf7020-1-check-for-valid-sync-byte-for-generation-of-interrupt

Regards,

Aldrich