ADF7030-1

Dear Sir,

How to test the receiver sensitivity in ADF7030-1 eval board?

  • +1
    •  Analog Employees 
    on Jan 25, 2019 3:38 PM

    Hi Veena,

    The ADF7030-1 supports the bit error rate (BER) test mode for sensitivity measurement. The Rx clock and Rx data can be made available at the GPIO pins of the ADF7030-1. 

    You may refer to the ADF7030-1 software reference manual and there's a section on the Receive Test Modes on page 38. You may also contact your local FAE to help you with your setup.

    Regards,

    Edwin