Hi Community,
Please advise how to use these two IRQ_CTRL_STATUS0 and IRQ_CTRL_STATUS1 register. It looks they have the same definition for each bit in these two registers.
regards,
ping
Hi Community,
Please advise how to use these two IRQ_CTRL_STATUS0 and IRQ_CTRL_STATUS1 register. It looks they have the same definition for each bit in these two registers.
regards,
ping
Hi Ping,
Please refer to the ADF7030-1 INTERRUPTS Section page 45 of the Software Reference Manual, which can be downloaded using the link below.
https://www.analog.com/media/en/technical-documentation/user-guides/ADF7030-1-UG-1002.pdf
Regards,
Ed
The '...STATUS0' register contains the interrupt status information for IRQ0 while the '...STATUS1' register contains the interrupt status information for IRQ1