EV-ADF70301-915AZ board has three antenna connectors two for Tx and one for Rx.
Please advise how to have ONLY ONE antenna, which can be shared by both Tx and Rx. What type of component should I use for switching in between Tx and Rx usages? Does ADI have such components that I can purchase?
Application Circuit Diagrams for single antenna applications are shown in figure 4, figure 5, and figure 6 of UG957 (https://www.analog.com/media/en/technical-documentation/user-guides/ADF7030…
contact local site analog devices taiwan. https://www.analog.com/en/support/technical-support.html
Application Circuit Diagrams for single antenna applications are shown in figure 4, figure 5, and figure 6 of UG957 (https://www.analog.com/media/en/technical-documentation/user-guides/ADF7030-1-UG-957.pdf ). Please contact your local FAE for in depth discussions about implementing these single antenna application circuits.
Your local FAE will be your design guide in selecting the proper Low Noise Amplifiers (LNA), RF Power Amplifiers, RF switch in the ADI porfolio which you can you for these application circuits.
Thank you, atolentino.
But how do I find my local FAE? This ADF7030-1 relevant project is handled by Taiwan workforce. Could it be possible that I contact ADI Taiwan branch? Please advise.