PHY_ON State vs PHY_TX State while ADF7030-1 is in transmit only operations

Question

Hi Community, 
 One of my ADF7030-1 design is in transmit only operations. 
 However, from PHY_TX State to PHY_ON State and from PHY_ON State back to PHY_TX State take up to 245 us each direction. 
 Is there a way to save the states transactions? I mean make ADF7030-1 stays at PHY_TX State even after notify TX_EOF either by software command or hardware signaling. Could this way increase the transmit rate? 
 
 regards, 
 ping

atolentino · Accepted Answer

Hi ping, 
 For Data Rates of 2.4kbps and 300kbps, PHY_TX to PHY_ON typically takes about 36 uS when Host initiated via CMD_PHY_ON command, and 26 uS automatically via TX_EOF command. This is shown in "Table 25. Radio Timing Specifications" of the ADF7030-1 Datasheet ( https://www.analog.com/media/en/technical-documentation/data-sheets/ADF7030-1.pdf) 
 You can see timing details of the PHY_TX to PHY_TX transition on the same table. Please contact your local FAE for in depth discussion about this. 
 Regards, 
 atolentino)

Electronic Design Services - PartnerZone

Products Mentioned

PHY_ON State vs PHY_TX State while ADF7030-1 is in transmit only operations