One of my ADF7030-1 design is in transmit only operations.
However, from PHY_TX State to PHY_ON State and from PHY_ON State back to PHY_TX State take up to 245 us each direction.
Is there a way to save the states transactions? I mean make ADF7030-1 stays at PHY_TX State even after notify TX_EOF either by software command or hardware signaling. Could this way increase the transmit rate?
For Data Rates of 2.4kbps and 300kbps, PHY_TX to PHY_ON typically takes about 36 uS when Host initiated via CMD_PHY_ON command, and 26 uS automatically via TX_EOF command. This is shown in "Table 25. Radio Timing Specifications" of the ADF7030-1 Datasheet (https://www.analog.com/media/en/technical-documentation/data-sheets/ADF7030-1.pdf)
You can see timing details of the PHY_TX to PHY_TX transition on the same table. Please contact your local FAE for in depth discussion about this.
Thanks again, Atolentino.