ADIS16460 IMU's with Raspberry Pi

Hi Ingrid

IngridM said:

2. I configure my Raspberry pi with overlay in boot/config.txt  (dtoverlay=adis16460)

Did you created an overlay for adis16460? AFAICT, there's no overlay in the pi branch so I do not thing you'll have on in the sdcard image... That means that no overlay will be loaded during boot and  your device won't show up in iio_info since it's not probed.

- Nuno Sá

Ok, thank you so much for your help!

Let me know if you need any help with the overlay. A good place to look is the adis16475 and the adis16480 overlays.

- Nuno Sá

Let me know if you need any help with the overlay. A good place to look is the adis16475 and the adis16480 overlays.

- Nuno Sá

Ok, tahnk you so much. Do you have the adis16460 overlay? (I don't understand very well

that codes)

Sorry for the late reply... Unfortunately, we do not have any overlay for adis16460. However, it should be pretty similar to what we have for the examples I pointed you.

Hello,

I had tried with two codes to see the answer for the IMU, but it continues without working.

I will show you the response of the IMU connected to the raspberry pi when I use the next two codes! The MISO have a offset level, but I don't receive anything!

1. case 1

import sys
import spidev
import RPi.GPIO as GPIO
import time
import array
from struct import *

spi=spidev.SpiDev()
spi.open(0, 0)
spi.max_speed_hz=400000
spi.mode=3
bcmRst=12
GPIO.setup(bcmRst,GPIO.OUT)
GPIO.output(bcmRst,GPIO.HIGH)

while True:
    res=spi.wrytebytes([0x56,0x00])
    data=spi.readbytes(2)
    print(data)
    
finally:
    spi.close()
    GPIO.cleanup()

• SCLK     CH1   (Yellow)
• MISO     CH2    (Purple)
• MOSI     CH3    (Blue)
• CS         CH4    (Green)

2. case 2

import sys
import spidev
import RPi.GPIO as GPIO
import time
import array
from struct import *

spi=spidev.SpiDev()
spi.open(0, 0)
spi.max_speed_hz=400000
spi.mode=3
bcmRst=12
GPIO.setup(bcmRst,GPIO.OUT)
GPIO.output(bcmRst,GPIO.HIGH)

while True:
    res=spi.wrytebytes([0x56,0x00])
    res=spi.wrytebytes([0x56,0x00])
    
    
finally:
    spi.close()
    GPIO.cleanup()

• SCLK     CH1   (Yellow)
• MISO     CH2    (Purple)
• MOSI     CH3    (Blue)
• CS         CH4    (Green)

I will be very grateful if you can help me or see something strange on the code! I always obtain the same answer.

I will be very attentive. Best regards!

Hi,

Using spidev is not the intended way to use devices and never did it myself. So, I'm not sure what's not working in here but I do know that these parts are typically very sensitive with spi timings and for example, the time delay between cs deassert and assert during a transfer. Another thing worth mentioning is the RST pin... Are you sure that's the correct one? And that the pin is active low?

You might also try to lower the max spi speed to see if it helps.

- Nuno Sá