How to enable 2 RX channel of adrv9009 base on adrv9009-iiostream.c?

On the adrv9009-ZU11EG Noticing discontinuities/saturation on the data on this set up when writing to disk vs when only one channel is enabled :( I have cma = 1024M set and also using tmpfs for optimal write speeds.

See those artifacts in the time series around 0.01s?

Yes frequency is configured before these code snippets.

wanted to see if I’m enabling the channels correctly.

thanks 

Child id should be 1 not 2 for secondary RX channels.

-Travis

Im trying to enable adrv9009-phy's primary RX channel and adrv9009-phy-b's primary RX channel.

I.e. the RX1 channel for each ADC, No secondary RX channels.

Then index 0 and 2 are fine.

-Travis

Hi Trav, I'm now using adrv9009zu11EG + fmcomms8. Has the adrv9009 iio streaming been tested for this hardware? CUrrently getting "Could not create RX buffer: Cannot allocate memory" ERROR.

Notice the destination bus width in the hdl is 128Bits.

This is the dts file arch/arm64/boot/dts/xilinx/zynqmp-adrv9009-zu11eg-revb-adrv2crr-fmc-revb-sync-fmcomms8.dts notice it says 256 bits for destination.

Max is 128 bits for HP

This, even when I only enable one channel from adrv9009-phy and not enable ling the other 7 channels.

adrv9009-iiostream from libiio/examples works. So I guess its just my code.

adrv9009-iiostream from libiio/examples works. So I guess its just my code.

Problem resolved?

-Travis