I use ZedBoard and EVAL-ADRV9002.
I tried to change the sampling frequency with IIO.
But it was fixed at 1.92MHz.
I want to use a sampling frequency of 48kHz, is this possible?
In order to change the sampling frequency you have to generate a profile and load it with TES. Check this wiki page for more details:
Sorry for the late reply.
I'm trying the method I was taught.
However, when using 2019_R2 (2021-02-23-ADI-Kuiper.img), "iio: device1: adrv9002-phy" could not be detected.
I copied the following files to the BOOT directory after creating the SD card.
1.BOOT.BIN and devicetree.dtb in zynq-zed-adrv9002
2. uImage in zynq-common
Please let me know if there are any other necessary steps.
Thank you for your reply.
I tested it with no cables connected.
and there were two stickers on my board.
This board detects "iio: device1: adrv9002-phy" on the SD card created in the dev_adrv9001_cleanup branch.
Please let me know if there is anything else I should do.