I am using KCU105 + FMCDAQ2. able to successfully communication over IIO plugin with IIO Oscilloscope and Visual Analog.
I am further interested to do processing on GNURadio as this our requirement . Can you kindly guide me how to use GNURadio with FMCDAQ2.
There are only support for FMCOMMS2/3/4 and not for FMCDAQ2 ( AD9680 / AD9144 ).
C P U
You can use the IIO Device Sink/Source blocks to talk to DAQ2.
"PHY Devices" will be blank and the "Device Names/IDs" would be "axi-ad9680-hpc" or "axi-ad9144-hpc".
Channel names will be "voltage0" and "voltage1".
You can lookup this info on the board or remotely using the "iio_info" and "iio_attr" tools.
Thanks for the reply.
I have installed Ubuntu on VirutalBox and followed the procedure as per link below to install GNURadio.
I am able to open the GNURadio GUI and add the source as per your suggestion.
Below are the screen shots of configuration and Error Port not connected.
My Target IP address is 192.168.0.118.
If i ping from Ubuntu VirtualBox the same IP it is able to ping the target.
Your Input on the will be appreciated.
Are you connecting the source block to anything?
No I am not connecting source block.
I am totally new to GNURadio. I have used VisualAnalog and IIO Oscilloscope.
If can help me out one flow I will be able to continue further.
- C P U
I have attached the GNURadio Project File . Kindly let me know i am still not able to connect to the source.
Awaiting for your reply.
- C P Uaxi-ad9680-hpc.zip