I have a ZCU102 and an ADRV9009.
I followed this
And run the commands
root@analog:~# iio_info | grep iio:device iio:device3: adrv9009-phy iio:device1: ad9528-1 iio:device6: axi-adrv9009-rx-hpc (buffer capable) iio:device4: axi-adrv9009-rx-obs-hpc (buffer capable) iio:device2: ad7291 iio:device0: ams iio:device5: axi-adrv9009-tx-hpc (buffer capable)
root@analog:~# fru-dump -b /sys/bus/i2c/devices/16-0050/eepromread 256 bytes from /sys/bus/i2c/devices/16-0050/eepromDate of Man : Wed Aug 30 14:05:00 2017Manufacturer : Analog DevicesProduct Name : 9379RC0,9528Serial Number : 1716630014Part Number : 9379FRU File ID : Empty FieldPCB Rev : 01BPCB ID : 9379CE01BUses LVDS : Y
Then I would like to use the IIO Oscillscope on my PC connected with Ethernet to the ZCU102+ADRV9009.
What IP address to use to connect to ZCU102 ?
This is not your ADRV9009, but our PanaTeQ's FMC-ZU2RF-A which is 100% HW/SW compatible with your ADRV9009 . We used the same FRU and your SW works straight forward !
Thanks for your efficiant support Travis !
Is the Obs RX working ? It does not work on my setup
TX1,TX2,RX1,RX2 are working on capture1 on the left.
OBS RX is on capture 2 on the right but looks no data to be displayed by the SW
You cannot use RX and OBS simultaneously. Make sure RX is powered down then power up OBS.
That's ok now. Thanks !
Do you know if the IIO software can work with different VCXO values than 128.880MHz ? We are offering 100.000MHz, 125.000MHz, 153.600MHz, 156.250MHz or 320.000 Mhz as optional on our FMC