ADRV9361-Z7035 U-Boot default configuration

While I appreciate that I'm hoping the source configuration file was available as well to create it from the ground-up.

For u-boot use master and the zynq_picozed_sdr2_defconfig.

-Travis

Thanks!

Turns out this may not be correct. When I use the u-boot generated from master using zynq_picozed_sdr2_defconfig I get the following message in u-boot when attempting to load the board,

U-Boot 2016.07 (Oct 12 2018 - 10:25:15 -0700)

Model: Zynq PicoZed SDR2 Board
Board: Xilinx Zynq
I2C:   ready
DRAM:  ECC disabled 1 GiB
MMC:   sdhci@e0100000: 0
SF: Detected N25Q256A with page size 256 Bytes, erase size 4 KiB, total 32 MiB
*** Warning - bad CRC, using default environment

In:    serial@e0001000
Out:   serial@e0001000
Err:   serial@e0001000
Model: Zynq PicoZed SDR2 Board
Board: Xilinx Zynq
Net:   ZYNQ GEM: e000b000, phyaddr 7, interface rgmii-id
eth0: ethernet@e000b000
Hit any key to stop autoboot:  0
Copying Linux from QSPI flash to RAM...
SF: Unsupported flash IDs: manuf 00, jedec 0000, ext_jedec 0000
Failed to initialize SPI flash at 0:0 (error -93)


When I use the canned u-boot form the 2018_R1 SD Card (which happens to be labeled u-boot-zed.elf) it can correctly access the flash part via qspi.


U-Boot 2014.07-dirty (Nov 20 2014 - 17:05:21)

Board:  Xilinx Zynq
I2C:   ready
DRAM:  ECC disabled 512 MiB
MMC:   zynq_sdhci: 0
SF: Detected N25Q256A with page size 256 Bytes, erase size 4 KiB, total 32 MiB
*** Warning - bad CRC, using default environment

In:    serial
Out:   serial
Err:   serial
Net:   Gem.e000b000
Hit any key to stop autoboot:  0
Copying Linux from QSPI flash to RAM...
SF: Detected N25Q256A with page size 256 Bytes, erase size 4 KiB, total 32 MiB
SF: 5242880 bytes @ 0x100000 Read: OK
SF: 131072 bytes @ 0x600000 Read: OK
Copying ramdisk...

Any ideas?

What is in your bif file?

-Travis