I generated profile for 61.44 MHz of the bandwidth of 40 MHz using the profile generator (available in this link). And I try to load using iio-oscilloscope (I pull the recent update and compiled again) since we are using ZCU102 and ADRV9009.
But it throwing the error as "Failed to load Profile using selected file". As shown in the screenshot.
What i am missing. How i suppose to load the profile that I generated using the profile wizard.
Moving to Linux driver forum
Which version of iio-oscilloscope & linux are you using ?
The new filter wizard generates some tokens which the driver might not handle, that's why the profile loading might fail.
The issue was addressed with this commit on your linux master branch:
I'll see if we pick this also onto your 2018_R2 release branch.
I'm using the linux version 2018_R1 sd card image that provided in this link.
The iio-oscilloscope is Analog Devices Inc. Industrial I/O Oscilloscope 2018_R1-g275435d.
The profile that generated, when I remove the following lines and changing the device clock driver to 2 with 122.88 MHz, it is loading without any error.
Can I load the profile without these lines.? Its only the enabling/disabling the TX/RX/ORX right?
So can I do this in the code that I use to receive the data or after loading into iio- oscilloscope can I control all those?