MAX96705/9/11 camera parts do not support splitter configuration however the MAX9271/9273 can be used in COAX Splitter Mode when both OUT+ and OUT- are outputting the same data. For more information see…
The combined impedance of the small inductors (L1/330nH and L2/6.8uH) is used to block the high-frequency forward video signal, 10MHz to 750MHz. The big inductor (L3/100uH) impedance is used for low frequency…
If raw data is used and DBL = 1, f or a given image resolution, the corresponding data rate required for the coaxial or twisted pair is:
(pixel row * pixel column) /2 * frames per second * 1.25 * 30…
Double mode (DBL) allows for the serializer to load a GMSL data packet with two half-width serial words instead of one whole-width one. Maxim GMSL parts have three different bus widths: 24, 27, and 32…
Question:
Some GMSL parts have a Local Control Channel ENable (LCCEN) pin so that a microcontroller can be connected directly (locally) to control the serializer. This pin changes the function of other…
Yes, the remote side I2C bus can run at a different speed than the local side. In a GMSL system, the controller is connected to the local device, while the coax/STP cable connects to the remote device…
An 'X' in a bit position can mean two different things depending on the situation:
1) If the 'X' is in a reserved bit position, the value is hidden and not accessible.
2) If the 'X' is in a normally…
图像分辨率对应的同轴线或双绞线信号传输速率为： （行像素 x 列像素） /2 x 每秒场数 x 1.25 x 30 （ 24-bit 模式） （行像素 x 列像素） /2 x 每秒场数 x 1.25 x 40 （ 32-bit 模式） 对于1280 P ，每秒 30 场的摄像头，同轴线或双绞线传输的最大速率为： （ 1280x1080 ） / 2 x 30 x 1.25 x 30= 777.6Mbps…
All Maxim Gigabit Multimedia Serial Link (GMSL) parts are compatible with each other. However, there are some constraints. If a serializer or deserializer has a feature that its companion does not, just…
