Post Go back to editing

ADM3054 1MHz Emission fails

Dear Sir,

ADM3054 1MHz Emission fails

We are using ADM3054 for Can isolation transiver.


From Our EMC emission test , we can see every 1MHz noise (which over some limit line on 100MHz)

After some investigation , we have find ADM3054 make this noise.

- With Near field probe , ADM3054 make 1Mhz noise
- Check LISN and 5V line of ADM3054 VDD2, we find it as attaced.

I am not familiar with  the internal architecture of ADM3054.
Why AMD3054 make this noise?
From ADM3054 datasheets, It's seem there is no active switching components on ADM3054.

I hope your helps.

Best Regards,
 

Parents
  • Dear ConalW

    Thank you for your comments.

    I know what there is no detail about refresh pulse in ADM3054's datasheets.

    But ...

    - Connect 5V Vdd2 and check it LISN , we could see the figures as attached.

    - With Near filed probe and Spectrum Analyzer , We Could see this noise near ADM3054.

    Of course , the typical solution is add some capaciter to Vdd1 and vdd2.

    But from some regulation of our products , we could not add capaciter in vdd2.

    That's why , We have difficultly to reduce this noise.

    Thanks & Best Regards,

Reply
  • Dear ConalW

    Thank you for your comments.

    I know what there is no detail about refresh pulse in ADM3054's datasheets.

    But ...

    - Connect 5V Vdd2 and check it LISN , we could see the figures as attached.

    - With Near filed probe and Spectrum Analyzer , We Could see this noise near ADM3054.

    Of course , the typical solution is add some capaciter to Vdd1 and vdd2.

    But from some regulation of our products , we could not add capaciter in vdd2.

    That's why , We have difficultly to reduce this noise.

    Thanks & Best Regards,

Children
No Data