Post Go back to editing

Value of Clearance and creepage

Hello

Our customer will use ADuM6402.

Could you give me your advice what do below difference of value of clearance and creepage  mean ?

VDE document downloaded on your web site says below.

Clearance: Over 8.5mm

Creepage: Over 8.5mm

(Please refer attached file P.16 psition 76)

ADuM6402 datasheet P.9 table 16 says below

Clearance: 8.0mm

Creepage 7.6mm ( RW16 package) ,  8.3mm(RI16 package)

Regards,

Terumasa

VDE0884-10_8-28-13.pdf
Parents
  • Terumasa-san: Sorry for the delay. I received a response back from our certification expert:

    The two agencies do their own measurements, and arrive at different values.  CSA is more conservative.  Unless the customer is tied to a certification agency, they can probably pick the one that fits his application best.

     

    Regards, Brian

     

Reply
  • Terumasa-san: Sorry for the delay. I received a response back from our certification expert:

    The two agencies do their own measurements, and arrive at different values.  CSA is more conservative.  Unless the customer is tied to a certification agency, they can probably pick the one that fits his application best.

     

    Regards, Brian

     

Children
No Data