About the minimum pulse width of the receiver input of ADM3065E

Hello Yuji,

Thanks for showing your interest in one of our RS-485 Transceivers. The maximum data rate that can be achieved with ADM3065E is 50 Mbps, but it also depends on the other working conditions like the temperature and supply voltage.  If you're increasing the data rate beyond that, the performance cannot be guaranteed. Also, according to the specifications listed for the conditions tested, the typical receiver skew/PWD for that part is around 1ns with the maximum being around 3ns. Make sure you're adhering to the specifications listed in the datasheet. Please refer to Table 5 in the data sheet for ADM3065E, ADM3061E/ADM3062E/ADM3063E/ADM3064E/ADM3065E/ADM3066E/ADM3067E/ADM3068E (Rev. G) (analog.com)

Regards,

Naveen

Hello Yuji,

Thanks for showing your interest in one of our RS-485 Transceivers. The maximum data rate that can be achieved with ADM3065E is 50 Mbps, but it also depends on the other working conditions like the temperature and supply voltage.  If you're increasing the data rate beyond that, the performance cannot be guaranteed. Also, according to the specifications listed for the conditions tested, the typical receiver skew/PWD for that part is around 1ns with the maximum being around 3ns. Make sure you're adhering to the specifications listed in the datasheet. Please refer to Table 5 in the data sheet for ADM3065E, ADM3061E/ADM3062E/ADM3063E/ADM3064E/ADM3065E/ADM3066E/ADM3067E/ADM3068E (Rev. G) (analog.com)

Regards,

Naveen

Although it was not listed in Tables 3 and 4, I understood that the minimum pulse width of High or Low needs to be 20 ns or more because it is MAX 50 Mbps. Thank you