Post Go back to editing

LTC4332 SS1-3 Pins

Hello

I am trying to use 2 LTC4332 ICs at default configuration. Do I need to use SS1-3 pins on the local side? Can I just simply connect them to GND or VL? Also when trying to send data to remote side, SSC pin of the IC is set to high. This is correct right?

Parents
  • Hello Gurhalil, I assume your question here is about the remote slave side? What should the remote LTC4332 's SSC pin connected to? is this what you asking? just fyi the datasheet at page 6, said, for SSC (REMOTE = 0) and When remote mode , leave SCC unconnected .  Also, what your final configuration looks like? Thanks

Reply
  • Hello Gurhalil, I assume your question here is about the remote slave side? What should the remote LTC4332 's SSC pin connected to? is this what you asking? just fyi the datasheet at page 6, said, for SSC (REMOTE = 0) and When remote mode , leave SCC unconnected .  Also, what your final configuration looks like? Thanks

Children
No Data