As mentioned in the last paragraph of page-20 of the Datasheet, ADN4654 can be used for isolating MIPI CSI-2.
I made a design like this. I found that when ADN4654 transmits high frequency HS-TX, the signal can be transmitted normally,
but when transmitting low frequency LP-TX, the signal cannot be transmitted normally.
Please refer to attached file.
Excuse me, what is the possible cause of the problem?
Thanks & Regards
The MIPI-CSI2 protocol not only uses differential signaling (which ADN4654 can isolate) but also has "low power" signaling where the exact same pairs of wires previously used for differential signals,…