Hi I just bought RAPID-NI-v2012 and am trying to integrate that into RAPID-NIEK-V0004.
I am trying to setup Network Interface EthernetIP for this module.
I am stuck at initializing this ethernet interface module when i run NI_TEST_IO.exe COM15.
The command returns :
Welcome to NI_Test_IO, version 1.3
Preparing to open communication port COM15Error 80 occurred while opening serial port COM15Error initializing communication port.
I am very new to this. Can someone help me set this up?
The NI_Test_IO executable will not accept COM port arguments with the COM port being higher than 9.
If you lower the number of the COM port in use in Device Manager, this error should go away.